Comment by thrdbndndn
3 years ago
Use filters.
I was also intimidated by the huge table and hundreds of columns the first time I use Digi-Key, but only later realized how handy it is to have all the parameters listed together. It makes comparison subtle difference of each parts so much easier.
The filter above will also tell you existing enum values within the current showing list, so you will instantly get an idea you are comparing.
Again, both have their advantages, but I recommend give it a try. Finding parts isn't any harder this way.
I use filters all of the time, but they frequently don't work (as mentioned but a sibling comment) sometimes the filter value don't allow a range so if you want anything between 10 and 100 you have to select all of the values between 10 and 100. Other times, the options aren't sorted so you have to select 10,000 uf and 10 mf and 0.01 F. Still other times numeric values are sorted alphabetically so you get 1 ohm, 1.1 kohm, 1.2 megaohm, 2 ohm, etc. So to select a range you need to clock through around the entire range of values looking for the order of magnitude you want.