Comment by ryao
3 days ago
I suspect this would cause alignment issues since you could literally rotate it into the wrong position when doing soldering. That said, perhaps they could get away with cutting less and using more.
3 days ago
I suspect this would cause alignment issues since you could literally rotate it into the wrong position when doing soldering. That said, perhaps they could get away with cutting less and using more.
They already have a notch or flat for alignment, which is much more critical during the lithography process than during soldering.
If you want to have nice straight edges to clamp into place, then you only need to shave off four slivers. You can lose a couple percent instead of more than a third.
You just need a sharpie to mark the top.