Comment by Saris
3 days ago
Their M12 batteries don't have balancing (or a BMS inside), so they go out of balance and 'bad' very quickly. I've just added a balance plug to the outside of mine that I plug into my hobby Li-ion charger.
3 days ago
Their M12 batteries don't have balancing (or a BMS inside), so they go out of balance and 'bad' very quickly. I've just added a balance plug to the outside of mine that I plug into my hobby Li-ion charger.
I believe you on the technical details, but as an anecdote, I have M12 batteries that are 10 years old and still working fine. At least, good enough that I have noticed no issues with them and I don't even know off the top of my head which of my batteries are newer and which are older. I also have a bunch of M18 tools and batteries, and I've noticed no particular difference in how they age compared to the M12 ones. But I'm just a DIY homeowner, so my usage is relatively light.
Yeah I figure most of them work fine, otherwise I'd find more similar stories.
We have about 10 of the M12 batteries, about half are the 3 cell ones and half the 6 cell larger capacity ones. And every single one has gone completely out of balance within 2 years of use.
I plug them into a balancer and they last another solid 6 months or so.
Fun fact, DeWalt 18/20V batteries also don't have balancing. The batteries have pins going to each cell for it but no chargers actually use them.
It's such a strange thing to do unless they wanted to intentionally make them have short lifespans.
The M12s have the pins too for voltage sensing in the charger (and tool maybe?), but they have 1 mega ohm resistors in line so cannot be used for balancing.
DeWalt also makes a series of batteries that will either provide ~20v (5s3p) or ~60v (15s1p) depending on the tool you plug it into. I've taken one of these apart before and how they implement this is just a mechanical switch between the cell groups, which only gets depressed when inserted into 60v tools. Not sure if thats why they put all the circuitry on the tool side, but I can't think of another good way to implement the same. (You'd need a pretty beefy boost/buck controller for the amps these tools pull )