Comment by ForOldHack
10 hours ago
The floppy disk usually made this straight up honking noise . I had a V20, but at 10Mhz. Never had a problem, except for formatting floppies. The V20 has a few tricks up it's sleeve, with a few less clock cycles on some instructions, and a Z80 mode to run cpm.
But,the real trick was to put real IBM roms in a clone board and run Xenix. When the clone roms are back in it still booted. Helped a lot to have a 2:1 Rll controller. Xenix was just pollute and delute - system V with some BSD thrown in and a slightly altered portable C complier that was later admitted to be wrong endian.
Did this Board have a FPU socket? Made turbo pascal run much faster. ( The 8087 version we got from the physics lab...) Especially the Hilbert matrix. And FFTs.
Why original IBM BIOS was requried for Xenix?!
The Roms it came with did not work, also the disks had to have perfect media. Everything bad to be formatted beforehand. So, I got IBM ROMS and it worked, then got some other roms so the keyboard speed switch would work, while the IBM ROMS were installed there was a simple program that would kick up the speed, and turn wait states off. It was slightly faster than a 6mhz AT for DOS and we did not have Xenix 286. Got me through K&R and passed the class, but do useful work? No.
We found out after the third try, that both the IBM and one of the clone BIOSes would run the install, and all of them would boot. ( And an OMTI Rll controller, supported... Dual hard disks too. ) I needed an assembly language program to much the speed up to 10mhz, and it still ran fine, right up to the 'make nethack' then 4 hours later...beeeep beeeep beep. OS not found. We never figured out weather it was a out of memory error or a temp file error ... But the OS was gone.