Comment by VLM

> You have to keep a parallel exponent calculation in your head, and that slows you down

We were taught to estimate and use the rule to refine. I date back to the early electronic calculator era and we still had textbooks referencing slide rules etc.

"I want a dropping resistor for a plain old 1980s LED in a car" (back in ye old red LED 20 mA days) "Well experience indicates that will be far more than 500 ohms and somewhat less than 1K and IRL you're probably going to install a 680 and call it good" If you want an actual calculation for engineering purposes you calculate the ideal value under worst case conditions as about 585-ish ohms or whatever using the slide rule, purchasing LOLs at the idea of buying 0.1% precision resistors for mere LEDs, installs cheap 680 ohms and ships it. Maybe 680s if you want it bright to see in daylight or 820 if you want better odds to survive an alternator field winding dump or open battery (about the same thing). You can at least use the slide rule to verify everyone rounded in the "safer" direction to handle the worst case scenario.