Comment by BrandoElFollito
5 days ago
> it's nonsensical to say tailscale works in places where wireguard is blocked
I have two machines on my desk, I configure a wg service on both. I also configure tailscale on both. Everything works.
I move one machine to another network, at a friend's place.
Wg does not work anymore. Tailscale works. So this is very much sensible to say what GP said.
Now, you can have all kinds of explanations about why wg dos not work and ts does, you know STUN, DERP, ts using wg under the hood, and whatnot but the facts are cruel: I cannot wg to my machine, but I can ts.
I was just pointing out that the statement wrt "wireguard being blocked while tailscale works" is nonsensical.
It remains nonsensical no matter how uninformed the user may be - even if he's proud of being such, as you seem to be.
This was not a discussion about what tool to use if the person doesn't know about networking and is generally ... "less technical".
Right, it’s that specific person’s Wireguard configuration, which is likely a typical one as a result of Wireguard‘s defaults. Tailscale‘s defaults work better, hence the surface-level impression that plain Wireguard does not work in cases in which Tailscale does.
As I said above - how would you set up plain Wireguard in a place without the possibility of exposing a port, or even that does not have a public IP - and initiate the connection from outside that place? I would love to learn something. Without rebuilding tailscale (or whatever other solutions with STUN or whatnot).
2 replies →
> even if he's proud of being such, as you seem to be
Of course on Internet nobody knows you are a dog. But hey, I may be someone who wrote a part of the Linux kernel in 1994, ran IT operations for a company that was big (big!) and then almost vanished (not my fault :)) and produces open source that you may have even used if you are "technical" as you say.
And set up WG in so many places, including a frontend that unfortunately did not get the worldwide success it should have :)
With this modest introduction - tailscale works where wireguard does not. I am not sure why my example was not obvious. You can reach the machine at my friend's with tailscale, not with plain wireguard. Of course if you open ports in the right places then yes! And check a few more things.
Now - how would you set up plain Wireguard in a place without the possibility of exposing a port, or even that does not have a public IP - and initiate the connection from outside that place? I would love to learn something. Without rebuilding tailscale (or whatever other solutions with STUN or whatnot).