Comment by defrost
16 hours ago
> A main component of why I was in sheer horror was the fact that I had stupidly buried all of these cables under my cement flooring in PVC trunking from my shelter to all of the rooms in the flat.
This I don't quite get .. as I understand it "PVC trunking" is a type of cable channeling / ducting.
I do a lot of cable and pipe layout around houses, farms, workshops, worksites, etc. and it's routine to use pipes / ducting / channels to allow other cables to be threaded through after or to replace bad cables.
As much as cable deterioration sucks it should be a relief to have ducting to pull good through after the bad.
The electricians mentioned that in order to curve the cables along underneath the floor tiling they couldn't use metal trunking which would cause sharp angles, so they used PVC pipes to do curvy trunking for the fibre cables. I could theoretically pull a new cable through by ripping out the wall outlet if this cable actually fails. You can see it in my earlier homelab post. But due to the length of the trunking and the number of bends, I'm not too sure if I can safely drag a new fibre cable through.
But yeah, maybe it's not that bad after all. I hope it won't get to that point.
I feel for you & yeah, fingers crossed :-)
One of my love / hates is Australian parrots and cockatoos - fantastic birds, noisy as hell - and they can rip out and shred unprotected wiring from rural camera and sensor systems like winged can openers.
> due to the length of the trunking and the number of bends, I'm not too sure if I can safely drag a new fibre cable through.
I saw someone commented elsewhere about a plastic bag and a vacuum. Another option to keep in mind is a lubricant intended specifically for the task of pulling cable through a conduit.
In the olden days, when things like TVs and VCRs had cabinets made from polystyrene and PVC-jacketed power cables, you'd often find that if something had been put away with the mains lead coiled up on top, it then left a "scar" on the case. This is because the plasticiser in the PVC jacket attacked the polystyrene, leaving the mains lead fragile and brittle and a nasty gooey mess on the case that you couldn't fix.
That's why the leads are wrapped in a polythene bag.
When people started using polystyrene sheet insulation in houses (thankfully they no longer do this!) the cables running inside the walls were affected in the same way, with the PVC insulation rotting off as the plasticiser leached out and attacked the polystyrene. Of course there you had the added joy of having a potential electrical fire with a source of just-about-inextinguishable fuel, the polystyrene foam made of fuel and air.
I wonder if something similar has happened here, something's gotten onto the fibre jackets and pulled the plasticiser out?