← Back to context

Comment by alienchow

13 hours ago

Hey actually I didn't know! It's my very first time dealing with fibre networking so I just maxed out the supposed durability specs. I figured I'd rather go overkill than regret not having done so. Ironic I know.

Unfortunately I can't easily dig the cable out and bury it again in this case. I'll have to figure out how to pull a new cable using the existing cable through the PVC conduits as the cable shares a larger conduit with multiple other fibre and Ethernet cables. The whole project was orchestrated remotely in a different timezone with me giving the electricians instructions over WhatsApp photos and audio recordings, so that limited what I could realistically control onsite back then. Often the contractors would proceed with a do first ask questions later approach while I was still asleep. The networking project was holding up the entire home renovation so everything was learnt and planned in a short amount of time.

AFAIK fibre splicing and terminating tools are very expensive. Do point me in the right direction for the $50 tools and I could go get some and DIY.

11 comments

alienchow

Reply
Sesse__  10 hours ago

> AFAIK fibre splicing and terminating tools are very expensive.

They're more like $600 expensive than $6000 expensive these days. For very low budget, you could go with a mechanical (aerobic) splice; it's more loss, less robust and takes up more space, but doesn't require a fusion splicer.

adinisom  13 hours ago

If you want to pull another cable:

- secure a string to the old cable

- pull the cable out the other end, pulling the string through

- secure the string to the new cable

- pull the string out the other end, pulling the new cable into position

  • alexfoo  12 hours ago

    You forgot to also tie another piece of string to the new cable so that you pull the new cable AND this other bit of string through.

    This gives you a piece of string in the conduit run to be able to pull through the next thing days/weeks/years later.

  • jaeckel  10 hours ago

    > [...] a string [...]

    Does someone have a recommendation for a specific material the string should be made of?

    • upofadown  9 hours ago

      Back in my day the local telephone company used waxed lacing cable for that sort of thing[1]. These days it seems that polypropylene string is popular (search on "conduit pull string").

      You basically want something that is slippery and will tend to not get stuck. I have used Dacron fishing line, but that is mostly because I had a bunch of it laying around.

      [1] https://en.wikipedia.org/wiki/Cable_lacing