Comment by irl_zebra
3 hours ago
I was resigned to running cat6e up three floors because there was only coax and I needed a wifi AP up there. Came across the moca solution and it's great. I get flawless 2.5gbe from the basement switch to the third floor over coax. It's basically a little device that connects at each end of the coax and cat6 goes in and out.
Cat 6 would be better though so I could run POE from the basement switch to power the wifi AP, and instead I need to go do a much more complicated switch (cat6) -> moca adapter + power brick to power moca adapter -> coax -> moca adapter + power brick (cat6) -> POE injector (with power brick) -> wifi AP. SO I'm adding at least three power bricks to the setup, which is annoying. Otherwise it would be one cat6 drawing POE from the switch and powering the AP.
You can run power over coax! You can buy power-injecting splitters that were used to power old analog cameras. They basically just connect the cable to the 12V, sometimes directly but usually through some current-limiting safety switch.
MoCA devices have a 100 Ohm internal resistor at the end to limit the cable echoes, so they are not affected by the DC on the cable.