Comment by MisterTea

What inverter hardware did you use?

I have an el cheapo 120 VAC 3600W import inverter with just two 100AH AGM batteries in series as it's a 24 VDC unit. Right now its all temporary and more experiment than practical.

Inverter mounted to a portable frame I built from bolted slotted angle with two battery shelves for a total of 4 batteries (only 2 now.) The batteries have a 200A terminal fuse and run through a 200A disconnect to the inverter using #2 AWG cable. The inverter, AC input, AC output are all grounded to a single ground bar that is bonded to the metal frame. AC Input is fed from a 12 AWG cord with 15A plug. AC output runs two 15A MCCB's, each terminated to a single socket hanging off a short whip cord. A cheap two wire digital DC volt meter is wired in series with a push button so I can see the battery voltage at a glance when I have the inverter powered down.

I temporarily setup the panels in my yard as an experiment but since I am in the city, I don't get good sun in my yard with all the obstructions. Honestly I ran it for two days, took the panels down before it rained, and didn't get a chance to measure anything. The panels really need to go on the roof and I have no intention of doing that any time soon.

The system did come in handy as a backup for my boiler when a wind storm knocked the power out for an hour and a half this past winter. I have thought about setting it up as a UPS for my little IT setup at home but 3600W is super overkill.