> how does [100BASE-TX] save power vs [1000BASE-T] running at low throughput?
100BASE-TX uses just two pairs (lanes), one for sending and one for receiving. 1000BASE-T uses all four pairs, for both sending and receiving. Therefore, a 100BASE-TX interface that's only receiving needs to power up one pair. A 1000BASE-T interface needs to power all four pairs all the time.
I recall reading about some extensions that allow switching off some of the pairs some of the time ("Green Ethernet"), but I think that they require support on both sides of the link, and I'm not sure if they are widely deployed.
> how does [100BASE-TX] save power vs [1000BASE-T] running at low throughput?
100BASE-TX uses just two pairs (lanes), one for sending and one for receiving. 1000BASE-T uses all four pairs, for both sending and receiving. Therefore, a 100BASE-TX interface that's only receiving needs to power up one pair. A 1000BASE-T interface needs to power all four pairs all the time.
I recall reading about some extensions that allow switching off some of the pairs some of the time ("Green Ethernet"), but I think that they require support on both sides of the link, and I'm not sure if they are widely deployed.
I assume it is for wake-on-LAN. This of course requires the NIC being powered on while the system is sleeping. Lower bandwidth mode = less power draw.