Comment by idiotsecant

Idk, I'd like to see AI design a schematic and lay out a board. Even the occasional "Show HN" that combines AI+PCB stuff is about analysis and checks. It doesn't seem like anybody is even near any kind of ECAD using AI. People still complain about autorouters. Even frontier models need architecting and guard rails in software to avoid spaghetti, it seems like an even harder problem to get them to choose the correct parts, create accurate footprints and symbols, and wire those all up together.

"This is wrong, fix it" + recompile, can happen twenty times in ten minutes, but "we discovered the layout is wrong, fix it" is precluded by the cost and time of a new board spin.

AI + text (code) seems like a good match but (E)CAD seems a lot harder to interface AI with. If I'm wrong, I'd like to share that with the EEs on my team, though.