Comment by jjav
14 days ago
> Even on older cars, service techs can typically manually push firmware updates
Older cars have no concept of such updates.
Happy with my 70s and 80s and early 90s cars.
14 days ago
> Even on older cars, service techs can typically manually push firmware updates
Older cars have no concept of such updates.
Happy with my 70s and 80s and early 90s cars.
Actually almost any fuel injected vehicle can accept flash updates through the port to at least the ECU and PCM, frequently the BCU is also write enabled.
If there is a BCM. My previous 1995 GMC C1500 had a PCM and the automatic transmission was controlled by mechanical linkage to a hydraulic computer in the transmission along with shift solenoids from the PCM. It also had "throttle-body injection" with two injectors replacing the carburetor. The OBD 1 system would switch to "open loop control" with preprogrammed injection in the event of a malfunction which would make the thing challenging to drive until you fixed the problem. So very simple compared to the multitude of computers and control systems in use today.
A nice feature on that system was that you could put a paperclip between two pins on the diagnostic port and it would blink out the trouble codes on the SES light.
You can adjust the ECU for these 80s and 90s cars and “flash” them like anything else. There’s just a lot less settings! Not sure about the 70s but I’m sure some resto-mods also allow for this.