Comment by bisby
2 hours ago
This is why I bought a 3d printer.
Headphone piece broke. Replacement was covered under warranty. Once. After that it was $30 a pop from amazon for the replacement part. Both of the parts provided under warranty (it was a set of 2) broke in the same way.
Figured if the parts break that regularly, I would wind up spending $500 in just a few years on replacement parts, might as well just get a printer. The part already had a model available (it was apparently a common issue), and the printed version hasn't broken yet.
I know nothing about making models, so the fact that the community already had the replacement part ready to print for me was a huge win, and Valve doing this basically guarantees that there will be a variety of "Controller stand, with puck slot" and replacement part prints available. HUGE win.
Fusion is a really cool tool to learn.
It's a flavor of 3D modeling called "constraint-based." You've heard the adage that if you give a million monkeys typewriters, eventually one will write something coherent? Constraint systems embody that same idea: There are infinite possible 3D models. You keep adding constraints until you narrow it down to only one possible solution that fulfills all of them.
I've been learning FreeCAD, while it's still more frustrating than Fusion or SolidWorks it's much better than it used to be pre-1.1, and it's FOSS. Also constraint-based, I've been using the new spreadsheet view as the source of all constraint dimensions, with parts derived by binding to top, front, or right-side orthographic "master" sketches. Much like hand-drawn design, where you draw the orthographic views and use those directly to create an isometric view.