Comment by gck1

I gave a fairly complex reverse engineering task to DS-4 xhigh and GPT-5.5 xhigh today.

After about 6 hours, both ultimately failed to fully RE, however, there were some drastic differences:

DS stopped every 30 minutes or so, saying it did full RE and it should all work now, while in fact, it didn't complete even 1% of it. It also looked for shortcuts again and again, despite me prompting heavily that the specific shortcut may not be used. It was a complete and utter failure.

GPT-5.5, on the other hand, blew me away. It just did the right things, didn't jump to next steps until it was sure it completed the initial layers and had a full understanding of what's required. The only time I prompted it during the 6 hours was when I saw it going in the right direction and I could nudge it slightly towards an even better way. I never felt I was fighting it. Okay, maybe a little bit - after compaction, it sometimes would go on a "no I'm not helping you with reverse engineering" tangent, but it would resolve in a clean session.

I cancelled my Claude subscription a month ago, so I haven't tested that, but DeepSeek has reminded me a lot of how I worked with Opus 4.6/4.7. Which perhaps could be a positive sign to some, but GPT-5.5 showed me that the way claude/ds work is just way too annoying.