← Back to context Comment by desdenova 4 hours ago This is closer to an open Sketchup than a Blender. I think they fill different niches. 2 comments desdenova Reply dofm 4 hours ago Much closer to Tinkercad in operation (negative solids etc.) thenthenthen 4 hours ago Agree, this is very much needed.. is there a repo? Would love to add fillets at some point
thenthenthen 4 hours ago Agree, this is very much needed.. is there a repo? Would love to add fillets at some point
Much closer to Tinkercad in operation (negative solids etc.)
Agree, this is very much needed.. is there a repo? Would love to add fillets at some point