Comment by mawadev

>assembly driver

>Way too easy to strip out the threads.

An "assembly driver" or "installation driver" is meant to describe low-torque powered screwdrivers. They don't strip threads especially when used on the lowest torque settings that can barely turn a screw before the clutch-release mechanism clicks. On the other hand, the high-torque powered screwdrivers that can turn drywall and deck screws and the impact drivers that can spin the lugs on car wheels are a different beast.

The bigger risk with IKEA furniture is hammering in the metal dowel pins (that interlock with the rotating cams) at a perpendicular angle to the flat board. You have to gently tap them with a hammer because it's too easy to puncture through the particle board.

Actually, the majority of "screws" to turn in a lot of IKEA furniture (e.g. bookshelves) are the cams instead of typical threaded screws. The cams only rotate 180 degrees so there's no time savings in trying to use a powered screwdriver.

Any drill nowadays would have a clutch. Use it, so it limits the torque. It applies for pretty much any kind of work (e.g. including mounting intake manifold on a lawn-mower, but then it's likely to use a torque wrench too)

Very true, I do it with regular screwdrivers but I watched people in the past ruthlessly overscrew and hammer stuff in, its not supposed to be done with force. My furniture so far survived 2 moves and 14 years with full disassembly and assembly in between..

These days I wouldn't recommend Ikea to anybody with the prices and build quality, Jysk is a good and cheap alternative in germany.

I feel like this shouldn’t be down-voted. I insist on grabbing The Gun for anything more than a few screws, but have definitely overtightened or cracked boards when I don’t keep the torque low.

Always remember the rule: a half-turn before breaking is how tight you want it to be