Comment by BenjiWiebe
10 hours ago
Some newer equipment has no service manual available.
It's a subscription, with a DRM system so you have to use their app to browse the manual, and you can't print/save more than a couple pages per month.
10 hours ago
Some newer equipment has no service manual available.
It's a subscription, with a DRM system so you have to use their app to browse the manual, and you can't print/save more than a couple pages per month.
That's why I won't touch new equipment with a ten foot pole. I buy old stuff and then end up having to do major rebuilds. I realize this is somewhat of a luxury, and damn is it nice.
In the last calendar year, this is basically the highlights (routine maintenance excluded):
On my Kubota L3010 I added remote hydraulics so I had to take all the bodywork apart. Discovered some rust, put about 20hr of panel beating, welding, and paint into the floor pan (NLA part, unfortunately). About 20hr after I got it all back together it started leaking hydraulic fluid from the clutch housing. So I get the privilege of doing all that disassembly again to split the tractor and replace the front driveshaft seal (suspected). It's a minor leak, so far, so this might wait a few years.
The 1998 12V 2nd gen Dodge is its own saga--new transmission, clutch, a bunch of paint work. Rebuilt the entire interior. Currently working on cleaning up wiring in the engine bay, killer dowel pin fix, fixing oil leaks from the injector pump gasket and vac/power steering pump, serp belt, crank balancer, etc. Still need to drop the fuel tank and replace the sending unit, as well as re-seal the axles.
My 1995 Land Cruiser just got new plugs, distributor cap/rotor, belts, crank balancer, front main seal, oil pump o-ring, etc. Should be good until next summer.
My 1999 Benz got some new A/C o-rings, all the low pressure fuel lines replaced, some rust repair (welding, panel beating, paint, undercoating, etc) on the front right jackpoint. All new stainless brake lines (https://www.linestogo.com/ 100% will buy from these guys again). This car is kind of sacrificial, eventually its engine (OM606) is going in the Land Cruiser in front of a purpose-built NV4500 transmission. If the rust doesn't get it first (ski bus duty), I'll probably shred the 722.6 by turning up the engine too much.
So it's not a small amount of work. But no reverse engineering is required. I can just read a book and follow the instructions therein and do literally anything that needs to be done on those vehicles.