Comment by walrus01
17 hours ago
My first thought was it'll be a lot easier to maintain if they put some sandpaper-like grip tread on those wooden ladder/stair steps. It comes in self-adhesive rolls, you peel and stick. Huge safety improvement for very little cost.
Without modifying anything intrusive to the mechanism, a cheap way of monitoring to make sure it's still running OK would be to install a low cost PoE IP camera mounted in such a way that it's aimed at the gear mechanism, then feed its video into something like Frigate. As cheap as $75 for a camera, some cat5e cable and staples to take the cable to where you need it, and an old desktop PC (plug it into anything that gives it a DHCP lease and default route outbound, make it a VPN client). You could also possibly use the camera to monitor the blinking status LED without doing anything intrusive to the existing electronics.
One other random thought: The battery in that photo looks like exactly the same size commonly used in emergency exit stairwell wall mounted battery-backed lighting systems, it's a 12V 7Ah to 8Ah AGM lead acid, rectangular/flat size. It should be fairly easy to find a replacement if needed from a local distributor of commercial electrician supplies/parts. Those things should go on a fairly frequent replacement schedule since they're held at 100% state of charge near constantly, and that one is probably exposed to hot summer sunlight temperatures in June/July/August. As a general rule if you don't know how old it is or have any records of when it was last replaced, it's time to replace it.
> Without modifying anything intrusive to the mechanism, a cheap way of monitoring to make sure it's still running OK would be to install a low cost PoE IP camera mounted in such a way that it's aimed at the gear mechanism then feed its video into something like Frigate. As cheap as $75 for a camera, some cat5e cable and staples to take the cable to where you need it, and an old desktop PC (plug it into anything that gives it a DHCP lease and default route outbound, make it a VPN client).
You can also just look at the clock from outside to see if it's got the correct time.
Sure, but that doesn't tell you if the gearing has bound up or the motor is trying to turn something and it's jittering back and forth (or a small trail of smoke has emitted from the motor 3 hours ago). Plus it's a fun thought exercise.
This came to mind because I recently had reason to set up automated sump pump monitoring for a rental property which doesn't have a proper basement, just a crawl space.
We had the choice of just installing a binary state (wet or not wet) zigbee liquid sensor, which we did, talking to a cheap USB dongle and home assistant, just above the height of the sump pump. But in addition to that I put a $60 camera which has a medium-wide overview of the whole crawl space, generally centered on the sump pit so that it can be checked in the event the liquid alarm goes off.
Stapled some cat5e across the floor joists that comes up through a small hole in the utility room where the PoE switch is. Theoretically it should also serve to check for things like "are raccoons inhabiting the crawl space?" or a few other possibilities.