I really hope they can keep the cost down, it needs to be in the "it's so cheap just hack on it" price range for not just engineers but kids too. I'm excited to see low-cost hardware put in the hands of kids with LLMs in their sails.
The CM4 and Pi 4 use the Cypress CYW43455 for Wi-FI, which I found to be unreliable. Under load, it crashes, and it can't be fixed in the kernel.
Frustratingly, many other SoMs and SBCs use this chip. I don't understand why there is no recall on this - in my opinion - trash product. It's an odd feeling to be the only one experiencing this. I am 100% confident this is a design flaw in the CYW43455. I've seen this also on a Pine64 CM4 compatible SoM, which has a completely different SoC. This is on both the official and custom carrier. Cypress, fix your shit!
I'm using the 2 W for a project and one thing I would love is for a better wifi antenna, the one that's on the 2 just isn't good enough. You can hack it though, there is a spot on the board where you can solder on a connector, cut a single trace and you're good to go. But it would be great if it would do better out of the box.
Amazingly powerful hardware for the price these little things.
I wouldn't hold out hope for an easier out of the box wifi antenna. If you want a U.FL antenna for the built-in wifi, there has to be a physical switch (cost, fragility) or a built-in antenna connected to U.FL you can replace (same issues) or the same cut and solder pattern for wifi antennas across chips like ESPs, nRFs, and others.
Totally. For my use cases, everything else is a nice-to-have. But I'm looking forward to ditching all my old micro USB cables. I have 6 Pi Zeros deployed and around twice that many ESP32s. I hate having to keep 2 sets of cables on hand.
The Pi zero is dead to me. Price might be one thing but lack of availability makes it useless. I like running Merves on it but will move to AtomVM and Esp32 where I can.
I don't see the need for an even more powerful Pi Zero. I'd say just have a modernized version of the original $5 single core Pi Zero, or ok the wireless version was good too. Maybe even have a 128MB config (original one was 512MB before the DRAM shortage) to keep the price down. Model A same same, who needs it if it's not a lot cheaper than the B.
I do like the Pico series and it would be cool to have one of those with memory protection.
I still havent been able to buy a Pi zero 2w from anywhere that isnt scalper prices. Zero is DOA if they cant actually manufacture them enough to get them into peoples hands.
there is radxa zero 3w, which on paper is nice looking board. bit dated maybe but still lot fresher than pi zero 2w. the rockchip soc should have decent mainline support and it has been around for a while
Seems like a good use for AI. If people can use it to port video games from one system to another or jailbreak consoles, surely "get this library/program compiling on this device, then get all the tests passing, here's root ssh and an internet connection" could work pretty well in most cases. I wouldn't have bothered wasting my time in the past, but now, sure why not? It's not my time anymore and AI can turn the crank until it works.
Yeah, I have a bunch of Radxa zero 3W, with their Rockchip rk3566. 4x A55 is just barely better than the A53 era still plaguing us 15 flipping years latter! Unbelievable. Alas just a hair before modern era of Rockchip, so it's support is much less consistent! But still pretty competent all in all!
Pine's Quartz64 has different peripherals attached but still afaik one of the best ways to track upstream support. It hasn't changed much since Linux 6.1 and I don't know if that's because there's nothing new or the page is just out of date. https://pine64.org/documentation/Quartz64/Development/
I tested te Pine64 SQQuartz CM4 compatible SoM, but it uses the same Cypress CYW43455 WiFi as the CM4/Pi4, which crashes on me under load (not the kernel, the chip itself). There is no fix or easy mitigation, other than lowering the load which only reduces occurence. I't odd that not many are talking about this.
Right. These days sdk or software doesn't matter much when I can easily vibe code stuff (which is what I have been doing). No matter the board, give me adb and watch me fully use it in an hour.
The biggest thing I want to see in a zero 3 w is not better cpu or ram, but wifi that isn't the zero 2 w spec of "2.4GHz 802.11 b/g/n wireless LAN"
Having at least 1x1 802.11ac that's capable of working in the 5050 to 5900 MHz band will be a huge feature improvement. Such as to connect to a 'modern' AP running in an 80 MHz channel.
There's tons of environments where 2.4 GHz is a CSMA hell of noise and the performance in a single 20 MHz channel will always be crap, and ranges/real world distances between AP and pi will be very limited because of the extreme noise in the 2.4 band.
It's hard to get too excited about anything coming from Raspberry Pi these days. Their anti consumer moves, weird accusatory social media positioning and obscene pricing just makes it all feel a bit like their relationship with B2C has gone very sour.
It's kind of insane how the higher end Raspberry PIs are almost as powerful as my PC tower. The price is quite low and developer friendly too. Really great products. The lower end products are awesome too.
It's one of the few products I look at with awe and which makes me feel good about the tech industry.
I managed to build a WiFi temperature sensor (which can be substituted with any analog sensor) which streams its data to a web platform (I also built), encrypted over HTTPS (with CA certificate verification), using a $10 Raspberry PI Pico W; built in a single weekend. I can connect it to my phone's WiFi hotspot from anywhere and stream data to my web platform where it displays a realtime chart. $10.
I really hope they can keep the cost down, it needs to be in the "it's so cheap just hack on it" price range for not just engineers but kids too. I'm excited to see low-cost hardware put in the hands of kids with LLMs in their sails.
That's what esp32's are for. $5 and uses fuck all power.
Those are entirely different operational models.
While people do often use pis to do things you could do with an esp32, an ESP32 cannot do the majority of things a Pi can do.
3 replies →
The original Pi Zero was $5, although it probably uses more power than an esp32.
3 replies →
The CM4 and Pi 4 use the Cypress CYW43455 for Wi-FI, which I found to be unreliable. Under load, it crashes, and it can't be fixed in the kernel.
Frustratingly, many other SoMs and SBCs use this chip. I don't understand why there is no recall on this - in my opinion - trash product. It's an odd feeling to be the only one experiencing this. I am 100% confident this is a design flaw in the CYW43455. I've seen this also on a Pine64 CM4 compatible SoM, which has a completely different SoC. This is on both the official and custom carrier. Cypress, fix your shit!
I believe that is actually a Broadcom chip, originally BCM43455.
I'm using the 2 W for a project and one thing I would love is for a better wifi antenna, the one that's on the 2 just isn't good enough. You can hack it though, there is a spot on the board where you can solder on a connector, cut a single trace and you're good to go. But it would be great if it would do better out of the box.
Amazingly powerful hardware for the price these little things.
I wouldn't hold out hope for an easier out of the box wifi antenna. If you want a U.FL antenna for the built-in wifi, there has to be a physical switch (cost, fragility) or a built-in antenna connected to U.FL you can replace (same issues) or the same cut and solder pattern for wifi antennas across chips like ESPs, nRFs, and others.
Just use a USB adapter with a decent antenna.
> there has to be a physical switch
Or literally any $1-3 SPDT RF switch? >80% of which are directly optimized and advertised for wifi and bluetooth?
2 replies →
There are RF connectors by Hirose which are bypassable due to a built-in switch, but I don't think pigtails with them are common.
Yeah I find the Pi's of that era have pretty poor wifi reception, has been a constant source of uncertainty when I run things on them sadly
If the Zero 3W has USB-C gadget mode support, a gigabyte of RAM and the Pi 4 chip, it’s going to sell very well indeed.
I hope they'll finally bring usb-c to the zero. Badly needed
Totally. For my use cases, everything else is a nice-to-have. But I'm looking forward to ditching all my old micro USB cables. I have 6 Pi Zeros deployed and around twice that many ESP32s. I hate having to keep 2 sets of cables on hand.
If only they'd keep the prices low and availability there. Things have been pretty bad since they've started moving out of the consumer market target.
The Pi zero is dead to me. Price might be one thing but lack of availability makes it useless. I like running Merves on it but will move to AtomVM and Esp32 where I can.
The lack of availability is basically the only reason they are releasing this new version.
They stopped making the lpddr2 dram that the old SoCs used a few years back, and now most of the stock has dried up.
The Pi 4 SoC used lpddr4, and I’m pretty sure they are still making it.
I don't see the need for an even more powerful Pi Zero. I'd say just have a modernized version of the original $5 single core Pi Zero, or ok the wireless version was good too. Maybe even have a 128MB config (original one was 512MB before the DRAM shortage) to keep the price down. Model A same same, who needs it if it's not a lot cheaper than the B.
I do like the Pico series and it would be cool to have one of those with memory protection.
I still havent been able to buy a Pi zero 2w from anywhere that isnt scalper prices. Zero is DOA if they cant actually manufacture them enough to get them into peoples hands.
there is radxa zero 3w, which on paper is nice looking board. bit dated maybe but still lot fresher than pi zero 2w. the rockchip soc should have decent mainline support and it has been around for a while
Decent support is not good enough. The Rasppi support is kind of an unsurmontable advantage.
Rpi is not always such a gold standard either.. is their boot chain still a mess? That was one of the problems with zero 2w
2 replies →
Seems like a good use for AI. If people can use it to port video games from one system to another or jailbreak consoles, surely "get this library/program compiling on this device, then get all the tests passing, here's root ssh and an internet connection" could work pretty well in most cases. I wouldn't have bothered wasting my time in the past, but now, sure why not? It's not my time anymore and AI can turn the crank until it works.
2 replies →
Rockchip has stellar mainline kernel support for most of their SOCs.
how close is the OS distribution for that to actual stock debian?
Stock enough that if I don't pay attention to which shell I'm looking at I can get confused.
Yeah, I have a bunch of Radxa zero 3W, with their Rockchip rk3566. 4x A55 is just barely better than the A53 era still plaguing us 15 flipping years latter! Unbelievable. Alas just a hair before modern era of Rockchip, so it's support is much less consistent! But still pretty competent all in all!
Pine's Quartz64 has different peripherals attached but still afaik one of the best ways to track upstream support. It hasn't changed much since Linux 6.1 and I don't know if that's because there's nothing new or the page is just out of date. https://pine64.org/documentation/Quartz64/Development/
I tested te Pine64 SQQuartz CM4 compatible SoM, but it uses the same Cypress CYW43455 WiFi as the CM4/Pi4, which crashes on me under load (not the kernel, the chip itself). There is no fix or easy mitigation, other than lowering the load which only reduces occurence. I't odd that not many are talking about this.
I only have one wish for the Zero 3 W: 1GB RAM. I’m not even asking for more.
2 GB RAM?
Better be $10-$15 to be of any use. There are MANY much better offerings now. Rockchip/Allwinner etc.
Yeah their software support is AMAZING!
Right. These days sdk or software doesn't matter much when I can easily vibe code stuff (which is what I have been doing). No matter the board, give me adb and watch me fully use it in an hour.
Original source article: https://www.phoronix.com/news/Raspberry-Pi-Zero-3-W-Pi-4-A
A Phoenix link is almonst never the "original article." It barely contains half the info OP's link does.
The article literally says "Phoronix spotted it first" in its first paragraph and provides that link, so the parent poster is quite mistaken.
1 reply →
Why a Pi 4 Model A and not a Pi 5? Perhaps because LPDDR4 is cheaper/more available than LPDDR4x?
The biggest thing I want to see in a zero 3 w is not better cpu or ram, but wifi that isn't the zero 2 w spec of "2.4GHz 802.11 b/g/n wireless LAN"
Having at least 1x1 802.11ac that's capable of working in the 5050 to 5900 MHz band will be a huge feature improvement. Such as to connect to a 'modern' AP running in an 80 MHz channel.
There's tons of environments where 2.4 GHz is a CSMA hell of noise and the performance in a single 20 MHz channel will always be crap, and ranges/real world distances between AP and pi will be very limited because of the extreme noise in the 2.4 band.
Can confirm. Unfortunately. Even so this form factor is really nice and it's cheaper than an Arduino and far more powerful.
Bluetooth 5.3 with LE audio would also be very nice.
Supporting WPA3 would be nice as well.
It's hard to get too excited about anything coming from Raspberry Pi these days. Their anti consumer moves, weird accusatory social media positioning and obscene pricing just makes it all feel a bit like their relationship with B2C has gone very sour.
Could we get one that has Ethernet only and no wireless connectivity? I am so sick and tired of the entire concept of "IOT".
can’t you disable it on the device? why would they make skus for this?
You clearly have no idea what IoT is if you think getting rid of wireless but keeping the ethernet port makes it not IoT.
It's kind of insane how the higher end Raspberry PIs are almost as powerful as my PC tower. The price is quite low and developer friendly too. Really great products. The lower end products are awesome too.
It's one of the few products I look at with awe and which makes me feel good about the tech industry.
I managed to build a WiFi temperature sensor (which can be substituted with any analog sensor) which streams its data to a web platform (I also built), encrypted over HTTPS (with CA certificate verification), using a $10 Raspberry PI Pico W; built in a single weekend. I can connect it to my phone's WiFi hotspot from anywhere and stream data to my web platform where it displays a realtime chart. $10.