Comment by esafak
18 hours ago
It's very easy since there is limited ability for trains to change tracks, so the location history of the train is a strong indicator of which track it is on. Even Google Maps can tell you which lane you are in since god knows when, and cars can freely change lanes. And that's just consumer software. For something commercial like a train they could trivially solve this problem with something more robust. But I'm not familiar with the Spanish system; how much of the engineering did they do?
There are switches that move trains between tracks. Now you need every switch to report, keep a history of that. Many trains also separate and combine. Trains sometimes go backwards to be switched.
It's not impossible. But handwaving GPS placement of trains at the correct location, direction, and track deserves more than a handwave as trivial.
All of those failure modes can be accommodated. I fail to see anything here a competent engineer couldn't address. I speculate it's not a technical problem, but an operational and cultural one. This is not rocket science.
But it must be also cheaper and more reliable than the current system, otherwise nobody is going to implement it.
4 replies →
Yes, it can tell you. How perfectly, though? Perfectly enough to bet 60 lives on?
When Google Maps gets wrong what lane I'm in, nobody dies. It can be right 99% of the time, that's good enough. It's not good enough for a train system, though - at least, I suspect it's not. I'd want a lot more than "it works in my car" before I trusted it.
Can we just have it as an additional data point, on top of what we should already know from where the train should be from switching history? If we get 99% accuracy, is that enough to check with an operator “specify which track you are in, left or right” when the measured value is different than the expected?
In addition to that being unpractical, the train doesn't even know the state of switches, i.e. not whether it is on the same track as some other position. It's just that this is undecidable for a single train. (This is what my first comment was about, it's simply not known how to solve it on the level of a single train, likely because it is impossible.) However the answer for what to do if a train can't trust the network, is don't move. Or move by sight, which is limited to 40km/h for good reason.
On the other hand this is a complete non-issue and solved for more than a century on the network level. So there is zero need to invent satellite or vision based train detection at worst even using statistical systems, when you can use deterministic systems, for example using the fact that a train is out of metal, so it's detectable by the train closing a electric circuit between the rails. Or using the sensors that are installed at every signal, switch or other positions for precisely this question.
HN does railway safety... The Dunning-Kruger level in this thread is ridiculous.
As a passenger, I'm very glad software engineers haven't (fully) taken over aviation and railway safety yet.
Google maps gives me the directions for the express lanes when I'm in the normal lanes and vice versa like 50% of the time, and that's an order of magnitude greater error in distance than the distance between adjacent train tracks. And several orders of magnitude greater failure rate than is acceptable for a safety system.
RTK is more than capable of figuring out what track you are on
It can be on the other track right now, but change to your track in the future. Or in other words, the topology of the network changes in operation. Whether the track you are on and the track another train is on, is the same or not is not decidable without knowing the current network state.