Comment by BuildTheRobots

9 years ago

I've looked into it in the past and keep looking at atleast a £500 cost -usually more if you want O2, CO, CO2, H25 (I think those were the ones I decided I was interested in).... and _then_ there's the certification cost, so I really can't justify it (though I'd love to).

My friends dad used to be a safety inspector duwnt' pit in the 70's and he's been trying to convince me to get an old Davy Lamp and to just pay attention to what the flame is doing, but I've yet to find a nice one (or inherit his). I have been known to ignite my cigarette lighter on every other rung when going down a ladder but in hindsight, that has the potential to end extremely badly.

11 comments

BuildTheRobots

Reply
e12e  9 years ago

Fun fact about CO, that may sometimes be overlooked: not only is it odourless and poisonous - but it's also highly flammable!

  • ptaipale  9 years ago

    Enough so that you can actually run an automobile engine on CO.

    Here in Finland, during second World War when petrol/gasoline was in very short supply, even army vehicles would run on CO gas. Petrol was only used for starting the engine.

    Starting a truck involved first chopping little pieces of wood to a reactor attached to the car or lorry, lighting them and creating a fire with suitable under-supply of oxygen so that the reactor emits CO. When the gas is at right concentration to burn, start then engine with petrol and then switch to CO gas.

    This is El Kamina, a modern hack made by the current Prime Minister in the country:

    http://jalopnik.com/el-camino-driving-jalopnik-endorsed-bada...

    Regarding its emissions, don't ask. Also, don't bother about burnout contests, it is not very powerful. But it runs on renewables.

  • BuildTheRobots  9 years ago

    Yeah, that's a very good point. It was suggested by an acquaintance that I just throw a lit sparkler down the hole before entering, which _almost_ made sense -though if I ever do manage to find a pocket of CO then it's going to make one heck of a mess.... Davy Lamp time it is then -big flame == big trouble and time to leave.

    I might have to start taking a household CO detector with me (the cheap ones now even have a PPM reading [1]) though I'm still wary of it giving a false sense of security and me then missing something else just as hazardous. Once again, Davy Lamp might be the solution to this -apparently the flame goes out when there's 17% oxygen or less, which is still life supporting.

    [1] http://www.amazon.co.uk/Mudder-Carbon-Monoxide-Alarm-Detecto...

    • e12e  9 years ago

      You know, if you're doing work, or going into enclosed spaces, you really should just get the best gas detector you can get your hands on. It's a lot better than dying.

      I worked for a short time at an installation that refurbished small oil rigs. It's about the worst kind of modern work environment: lots of poisonous substances (eg. heavy oil/crude leftovers), welding in closed spaces, tight crawlspaces and the whole thing is a basically a set of Faraday cages, so both VHF and cell reception is pretty bad.

      Basically when you opened up a tank, you'd first have someone lower down a high precession meter to sample it over 12 hours. If that looked good, you have at least two gas meters per team, and the team is in constant contact with someone outside (either by said crappy VHF, and/or supplemented with a rope - pull the rope every minute - sound the alarm if the signalling stops, and send in a rescue team. If you figure an excellent 5 minutes from alarm to the team is inside, that's 6 minutes without air).

      Worst accident we had was due to faulty documentation: a rig had stopped over and done an undocumented paint job. A team was repainting that section, on the inside of an enclosed space (a shaft) while another team was doing hot work (welding and/or cutting) on the outside. The old paint on the inside had cadmium in it - the result was 5-7 people airlifted to the hospital with cyanide poisoning.

      4 replies →