Comment by sgtnoodle
5 years ago
How would you tension the three gears to provide the right amount of pressure across variations in filament diameter?
I wonder how much wear there would be in the spiral sliding across the gear teeth.
5 years ago
How would you tension the three gears to provide the right amount of pressure across variations in filament diameter?
I wonder how much wear there would be in the spiral sliding across the gear teeth.
>> How would you tension the three gears to provide the right amount of pressure across variations in filament diameter?
Good question. The teeth should be 1/3 apart, so maybe just dig in if the filament is too thick?
There has to be a way, it's just too bougie not to exist.