Comment by timewizard
1 month ago
It doesn't require IPv6. The modem is just as aware of all the private IPv4 addresses on your network as well as all the public IPv6 ones.
Unless you put your own gateway (layer 3 switch, wifi ap, linux router) in front of it.
From my understanding it tracks signal strength between two points (gateway and printer for example).
Putting your phone in airplane mode doesn't make it think you have left the house.
> If you’d like to prevent your pet’s movement from causing motion notifications, you can exclude pet motion in your WiFi Motion settings by turning on the Exclude Small Pets feature. > Motion is detected based on the amount of signal disruption taking place between the Xfinity Gateway and your selected WiFi-connected devices, so motion from small pets (around 40 pounds or less) can be filtered out while keeping you notified of large movements more likely to be caused by humans.
That would require Comcast to have access to your router, or more precisely, the NAT.
Comcast sells a router gateway combination device that's probably required for this motion sensing anyway. If you have that they could already check device counts and in fact their Xfinity app lists connected devices in detail.
For most people their Comcast modem _is_ their router.
The point of the comment about ipv6 is that if you don't use a Comcast modem/router or they're prohibited by law from snooping on that, Comcast can still sorta understand the number of users from the outside by looking at your ipv6 addresses.
1 reply →