Comment by parpfish 7 months ago If convex curves are too hard, just make a concave curve and keep the other side. 3 comments parpfish Reply xattt 7 months ago I am not sure if this is board stretcher-level pranking or actual advice. Bravo! WillAdams 7 months ago The problem of course is that often one side of the curve is mangled/distorted from fitting the tool into it --- guess which one it usually is? junga 7 months ago It's always the side you want to keep of course.
WillAdams 7 months ago The problem of course is that often one side of the curve is mangled/distorted from fitting the tool into it --- guess which one it usually is? junga 7 months ago It's always the side you want to keep of course.
I am not sure if this is board stretcher-level pranking or actual advice. Bravo!
The problem of course is that often one side of the curve is mangled/distorted from fitting the tool into it --- guess which one it usually is?
It's always the side you want to keep of course.