failing to lift is not the same as lifting until failure.
Consider, if I load up the bench press to 200kg I won't get a single rep. If I try to rep it I'll fail but I'm not lifting until failure.
If I load it up to smaller weight lets say 100kg and crank out rep after rep I'll get much closer to "lifting until failure."
When I reach the end, the last rep is a rep I won't make. But I'm still not at a point where I can't do no more, just the weight is too big, so I must reduce the weight and go again. When I do this I get even closer to "lifting until failure".
It's like integration, the smaller the infinitesimal the closer to the true value you get when you sum up (integrate) all the parts.
While technically true getting very close to failure is only useful if you don't need optimal results and lack the time to do more volume. The damage by going to failure will make high volumes maintained over time impossible.
Ideally you would leave 1-2 possible reps. I think it's important to train to failure to know your body and learn to gauge your reps to failure but other than that and very little time per week to train it's eventually counterproductive.
And if training with lower weights you tend to end very far from failure if just following a program without knowing what you are doing.
Volume itself is meaningless. The only thing that matters is the intensity of the workout. In fact you want the maximum intensity with minimum volume to have less wear and tear and more recovery while maximizing the growth stimulus.
First intensity. Then recovery. These two dictate the volume. If volume exceeds recovery injury and burnout will follow.
False,
failing to lift is not the same as lifting until failure.
Consider, if I load up the bench press to 200kg I won't get a single rep. If I try to rep it I'll fail but I'm not lifting until failure.
If I load it up to smaller weight lets say 100kg and crank out rep after rep I'll get much closer to "lifting until failure."
When I reach the end, the last rep is a rep I won't make. But I'm still not at a point where I can't do no more, just the weight is too big, so I must reduce the weight and go again. When I do this I get even closer to "lifting until failure".
It's like integration, the smaller the infinitesimal the closer to the true value you get when you sum up (integrate) all the parts.
While technically true getting very close to failure is only useful if you don't need optimal results and lack the time to do more volume. The damage by going to failure will make high volumes maintained over time impossible.
Ideally you would leave 1-2 possible reps. I think it's important to train to failure to know your body and learn to gauge your reps to failure but other than that and very little time per week to train it's eventually counterproductive.
And if training with lower weights you tend to end very far from failure if just following a program without knowing what you are doing.
Volume itself is meaningless. The only thing that matters is the intensity of the workout. In fact you want the maximum intensity with minimum volume to have less wear and tear and more recovery while maximizing the growth stimulus.
First intensity. Then recovery. These two dictate the volume. If volume exceeds recovery injury and burnout will follow.
6 replies →