Comment by mindslight
6 hours ago
I've really got to get back into 3D printing. I was building a Voron back when it would have been like serial number 20. Got it to the point where I was printing its own parts (using stub parts made of plywood and whatnot). Life happened, I disassembled it to move, and I've still got the frame sitting around plastic-wrapped for the past ten years.
I wasn't even thinking LED fixtures. For LED fixtures with built in power electronics, I would definitely want the product to be NRTL recognized.
I was late to the 3d printing game and in part that was just not wanting it to become a junk factory of disposable toys and fidgets. I've definitely printed a bit of that kind of thing but overall I've been pleased with the number of small household fixups that it's been possible to do using it.
Just last night for example my microwave oven stopped registering that the door was closed, and within a few tries I was able to print a replacement for the latch bracket that had broken off. At any previous time in my life that would have been either a whole new door or replacing the entire unit.
For sure, I've got a list of "household fixups" to print when I finally do get around to rebuilding the thing.
Just a note of caution about the microwave though. I don't know what bracket broke off your microwave, but usually the door switch is a safety mechanism to make sure the door cannot be open while the magnetron is on.. Make sure a new 3D printed bracket isn't able to break off and cause the safety switch to remain on!