Comment by dekhn

I don't have a Bambu; previously, I had Prusa printers from the MK3 generation and I struggled to get good prints (poor bed adhesion and the extruder breaking frequently, requiring very intensive repairs); since not having a working printer slows my hobbies down, I ended up with two. Both broke down and I got tired of fixing them, but when I looked at the prices of new Prusa, they were high enough to make me pause.

Instead of a Bambu, I got a Flashforge Adventurer 5M. It is incredibly cheap (cheap enough that I am more than happy to replace it after two years if it stops working), and is pretty reliable (compared to the Prusa MK3 and MK3S I had), and most of all, the self-calibration works well enough that I don't spend any time debugging prints that fail at the first layer anymore; I just re-run calibration and it's fine, and if it's not fine, I clean the plate and it works.

It also comes with a terrible slicer (dervied from Slic3r I believe) with annoying "log into the cloud every time you start the app", but I moved to OrcaSlicer. I had to give up a few nice features but it hasn't truly impacted my workflow. And it does receive firmware updates (it's connected via wifi to my home network). My hope- just a hope- is that they don't do anything truly stupid with future firmware updates or end up getting in a hissy fit with prominent youtubers.