Comment by Auracle

There’s no reason to be nervous.

You can use their slicer (which works well!). If you don’t want to, you can use one that sends through their Bambu Connect software, which Orca Slicer doesn’t want to support for…reasons. Or you can use it in LAN mode. Or you can just transfer the gcode via an SD card or flash drive like ye olde days.

Despite the tone of the other reply to your question, they are absolutely the easiest printers to work with. I don’t love their new multicolor solution for how slow it is compared to other options, but that would be the only real fault with their newest line.