Comment by dhfbshfbu4u3
9 hours ago
Still a long way from shorting Autodesk.
As a side note Autodesk released an agentic assistant back in December for Fusion. Six months later it is still quite bad.
9 hours ago
Still a long way from shorting Autodesk.
As a side note Autodesk released an agentic assistant back in December for Fusion. Six months later it is still quite bad.
It is almost comically bad. I've had a few simple parts to design for 3d printing in the last weeks and tried it with them (each are about 4 operations on the timeline), and it never created close to what I was trying to do even if spelled out step by step according to Fusion naming.
At this point I'm not even sure if it can properly create a simple primitive solid.
Have you yet tried the Fusion MCP that was launched last month? https://aps.autodesk.com/blog/bringing-fusion-claude-creativ...
Still a long way to go, but I'm sure it will get there eventually.