Comment by phkahler

>> Also why do you need 1uS for motor control?

It's not that important if you use current sensors on the motor phases. But then you're looking at HALL sensors or a shunt with a very high gain amplifier with good common mode rejection - looking for mV signals on top of a +12V or +48V square wave at PWM frequency.

By using low-side shunts under each half-bridge you don't need the common mode rejection, but you can only measure phase current while the low side FET for that phase is on. That means limiting the PWM duty cycle to ensure that FET is on long enough to measure current, so we trade available voltage range for sample time.

I've also written code to measure all phase voltages with a single low-side current shunt under the whole 3-phase bridge. That requires careful phase shifting of the PWM signals and very fast conversion time, but you don't have to compromise available voltage range 0-100 percent duty cycle is possible.

Typically we run the control loop at PWM frequency, but the measurements need to be faster than that.