Comment by oefrha
6 hours ago
Not sure if it’s just me but in Codex, GPT-5.6-Sol and IIRC older 5.5 models can stop dead in the track a couple times a day saying “model is at capacity” (paraphrasing). Then I wait a minute or two and ask it to continue and it’ll more often than not happily use the same model. These frequent mini “outages” are pretty annoying especially if one isn’t supervising. Claude has had long outages but I haven’t run into this kind of mini outages on a daily basis recently.
Hermes seems to pick up after a stoppage. At least I've never had to push it again, it might just take a long time to finish a task and then I'll see the messages in the transcript.
I wish the harnesses would auto resume but I suppose that would also add more load without more money for subscription customers...
OpenCode has an autoretry functionality (that progressively waits more after each failed request). I m surprised other harnesses don't have that.
in the codex case, it will keep going it is not a blocking prompt.
That happens to me constantly with codex