Your post and the link to KiCadRoutingTools is going to result in me finishing a project I started 6 months ago and have just let sit and linger because, like you point out, it was only the boring parts left. Fable found a bit of a showstopper in my design yesterday (an LDO that was right near its limits) and suggested a replacement, Opus filled in all of the missing pull-up/pull-down resistor values, double-checked all of the decoupling caps, and then did floor planning on the PCB side. I just installed KiCadRoutingTools and am getting close to happy with the state of the board and will likely be ordering them tomorrow!
Your post and the link to KiCadRoutingTools is going to result in me finishing a project I started 6 months ago and have just let sit and linger because, like you point out, it was only the boring parts left. Fable found a bit of a showstopper in my design yesterday (an LDO that was right near its limits) and suggested a replacement, Opus filled in all of the missing pull-up/pull-down resistor values, double-checked all of the decoupling caps, and then did floor planning on the PCB side. I just installed KiCadRoutingTools and am getting close to happy with the state of the board and will likely be ordering them tomorrow!
Great to hear :) I hope your boards will turn out perfectly fine.