Better CPU selection. Embedded almost always have power requirements and you need to put your CPU into a low power mode not a loop which is running fast. You can also design your hardware such that you can turn the power off completely in these cases (or perhaps reboot).
Now that I think of it, a different project (I worked just down the aisle, but I wasn't on it) solved a lot customer complaints by turning all the "while(1);" loops into blink an error code - which since it does IO is defined behavior. Which probably is the correct answer to your question - don't just spin doing nothing, spin in such a way that the user has a clue why nothing is working (and in turn you can find out and perhaps fix real world bugs)
This is myopic. In many cases it takes time, and sometimes considerable programming effort, to enter and exit low power modes. So you don't do it willy-nilly; you do it when you believe the system has quiesced. That means, on a purely interrupt driven system that is not yet ready to sleep, the code may very well be spinning in an empty infinite loop somewhere.
There's no need to inform the "user" because there's nothing wrong with the system. Its simply waiting until the benefit of sleeping outweighs the cost of getting there.
Better CPU selection. Embedded almost always have power requirements and you need to put your CPU into a low power mode not a loop which is running fast. You can also design your hardware such that you can turn the power off completely in these cases (or perhaps reboot).
Now that I think of it, a different project (I worked just down the aisle, but I wasn't on it) solved a lot customer complaints by turning all the "while(1);" loops into blink an error code - which since it does IO is defined behavior. Which probably is the correct answer to your question - don't just spin doing nothing, spin in such a way that the user has a clue why nothing is working (and in turn you can find out and perhaps fix real world bugs)
This is myopic. In many cases it takes time, and sometimes considerable programming effort, to enter and exit low power modes. So you don't do it willy-nilly; you do it when you believe the system has quiesced. That means, on a purely interrupt driven system that is not yet ready to sleep, the code may very well be spinning in an empty infinite loop somewhere.
There's no need to inform the "user" because there's nothing wrong with the system. Its simply waiting until the benefit of sleeping outweighs the cost of getting there.
The context here is an infinite loop with no side effects. You have all the time needed to enter those states.
2 replies →
AVRs have SLEEP instruction.